Linksys / Sipura ATA (PAP2T + Compatible) Manual Configuration
← How-To Guides
Linksys / Sipura ATA (PAP2T + Compatible) Manual Configuration
Section titled “Linksys / Sipura ATA (PAP2T + Compatible) Manual Configuration”Use these instructions to manually configure a Linksys or Sipura ATA adapter for use on the SIPSTACK network.
Step 1: Find the Adapter’s IP Address
Section titled “Step 1: Find the Adapter’s IP Address”- Connect a phone to Line 1 on the adapter.
- Dial
****(four asterisks). - When prompted, dial
110#. - The system will play back the adapter’s current IP address (e.g.,
192.168.1.2).
Step 2: Access the Web Interface
Section titled “Step 2: Access the Web Interface”- Open a web browser on a computer connected to the same network.
- Enter the adapter’s IP address in the address bar (e.g.,
http://192.168.1.2). - Press Enter.
Step 3: Log In as Administrator
Section titled “Step 3: Log In as Administrator”- Click the Admin link on the page.
- After the page reloads, click Advanced View.
Step 4: Configure Line 1
Section titled “Step 4: Configure Line 1”- Select the Line 1 tab.
- Fill in the following fields:
| Field | Value |
|---|---|
| NAT Keep Alive | Yes |
| NAT Mapping/Traversal | Yes |
| Proxy | Provided by your SIPSTACK support team |
| Register Expires | 180 |
| Proxy Fallback Intvl | 180 |
| Display Name | Your name or company name |
| User ID | Your SIPSTACK username |
| Password | Your account password |
Step 5: Save Settings
Section titled “Step 5: Save Settings”Click Save Settings at the bottom of the page. The adapter will apply the new configuration.